Classe Audio CP-500 - V2.8 Manuel de service télécharger pdf (Page 29)

PowerFLARM Device Manual for FW v2.00

Essential Settings Prior to First Flight

There are a number of device settings that must be configured

prior to the use of the device. These are aircraft-specific settings,

that can be found under 'Settings > 'Aircraft'. The values chosen

depend upon the aircraft and must be altered before the device is

used in another aircraft.

These settings are mandatory for correct operation

of the device.

Selection of Aircraft Type

This setting is required to specify the type of aircraft in which

your device will be used.

Selection of Battery Type

Default is set to disposable Alkaline batteries, set to rechargeable

type if that is used for correct battery level indication.

The integrated charging circuit does not know about

the battery setting. It will attempt to charge any

type of battery if the device is connected to a power

source. Never connect the device to a power source

when Alkaline batteries are installed.

Transponder

Select whether your aircraft has an operating transponder (any

Mode) installed and switched ON, or not.

ICAO Address

Under this heading the user enters the hexadecimal ICAO address

of the aircraft in PowerFLARM device, also known as Mode S Code.

The aircraft address or Mode S Code is the aircraft-unique address

assigned by your Civil Aviation Authority, regardless whether you

have a Mode S transponder or not; in case your aircraft is

equipped with a Mode S transponder, this is the address

transmitted by the transponder.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Classe Audio CP-500 - V2.8 Manuel de service Page 29