Classe Audio CP-500 - V2.8 Manuel de service télécharger pdf (Page 10)

April 3, 2012

On the Data Port connector, PowerFLARM can transmit a

combination of GPS, traffic and alarm information to various types

of devices (e.g., external displays, flight computers, loggers etc.)

The type of data output and the connection parameters (Baud

rate) can be configured from the Menu or by commands on the

Data Port itself.

As of Firmware version 2.00, PowerFLARM implements versions

3, 5 and 6 of the Data Port specification with GPS/FLARM

proprietary NMEA and Garmin TIS data. The connected device

can select the protocol version it requires.

Please refer to the Data Port Specification available from

http://www.flarm.com/support/manual/ for details.

If you connect a device to the Data Port, make sure

that the installation conforms to the requirements

set forth in the Data Port Specification.

Do not connect more than one device at the same

time.

Audio

The audio signal is a standard de-coupled aviation signal of no

more than 1 V. The connector is a standard 3.5 mm jack plug.

Communications Antennas

The primary communications antenna for the

FLARM/PowerFLARM device communication must be connected

to the socket labelled ‘FLARM A’. For proper operation the

included ADS-B antenna (blue label) must be carefully and tightly

screwed to the rpSMA socket labelled ‘ADS-B’.

Make sure the FLARM antenna and the ADS-B antenna

(blue band) are not accidentally swapped!

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Classe Audio CP-500 - V2.8 Manuel de service Page 10